Mass recovery adsorption refrigeration cycle—improving cooling capacity

The study investigates the performance of two-bed, silica gel-water adsorption refrigeration cycle with mass recovery process. The cycle with mass recovery can be driven by the relatively low temperature heat source. In an adsorption refrigeration cycle, the pressures in adsorber and desorber are different. The chiller with mass recovery process utilizes the pressure difference to enhance the refrigerant mass circulation. Cooling capacity and coefficient of performance (COP) were calculated by cycle simulation computer program to analyze the influences of operating conditions. The mass recovery cycle was compared with conventional cycle such as the single stage adsorption cycle in terms of cooling capacity and COP. The results show that the cooling capacity of mass recovery cycle is superior to that of conventional cycle and the mass recovery process is more effective for low regenerating temperature.     

Measurements of gamma-ray emission probabilities of 241, 243Am and 239Np

Gamma-ray emission probabilities of ^{241, 243}Am and ²³⁹Np have been precisely measured with gamma- and alpha-ray spectroscopic methods. The activities of the samples were determined by measuring alpha particles using a Si semiconductor detector. Gamma rays emitted from the samples were measured with a planar type High-Purity Germanium (HPGe) detector. An efficiency curve of the HPGe detector was derived with uncertainties from 0.7% to 2.5% by combining measured efficiencies and Monte Carlo simulation. The gamma-ray emission probabilities for the major gamma rays of these nuclides were determined with uncertainties less than 1.2%.     

Experimental study of neutron counting in a zero-power reactor driven by a neutron source inherent in highly enriched uranium fuels

Even a zero-power reactor core containing highly enriched uranium has a weak neutron source inherent in uranium 235, and consequently, a neutron counter placed closely to the core without external neutron source registers a certain counting rate. The study of the counting is very important for zero-power reactor physics experiments with a high precision. In this experimental study, first, at a shutdown state of the UTR-Kinki reactor without start-up neutron source, a pulse height distribution of output signals from a neutron proportional counter was measured to confirm that these signals resulted from neutron detections. At several subcritical states of the UTR, then, the Feynman-α analysis was carried out to confirm that the neutrons detected by the counter must be fission neutrons multiplied by fission chain reactions. The correlation amplitude measured in the Feynman-α analysis was much higher than that measured in a previous drive by start-up source. Further, it was also confirmed that the subcriticality dependence of neutron counting rate followed the source multiplication formula. This feature indicated that the one-point model was very successful in the subcritical range including the shutdown state.     

Supramolecular morphology of two-step melt-spun poly(dioxanone) fibers

Structure of poly(dioxanone) (PPDX) fibers produced through a two-step melt-spinning process with an additional short-period annealing above the melting temperature of PPDX was investigated and the effect of annealing on the degradation behavior was discussed. The morphological study carried out by etching the fibers using a phosphate or permanganate solution suggested that the fibers take a skin–core structure, and both the skin layer and the core region consist of a bundle of microfibrils. The micro-beam X-ray diffraction analysis revealed that the short-period annealing in the production process only slightly promotes the crystallization in the skin layer but contributes to increasing the packing of amorphous chains near the skin, which seems to be the controlling factor of the hydrolytic degradation behavior of the fibers.     

Inter-comparison of various global sea surface temperature products

In this study, eight global sea surface temperature (SST) products for 2009 are compared to clarify their characteristics. The median of eight daily values, the Ensemble Median as Reference Product (EMRP), is used as a reference product for inter-comparison. The results show that the absolute value of mean differences and the value of root mean square (RMS) differences are higher in single-microwave products such as Advanced Microwave Scanning Radiometer for the Earth observing system (AMSR-E), Tropical Rainfall Measuring Mission Microwave Imager (TMI), and WindSat, than in products such as MicroWave Optimally Interpolated SST (MWOI), Merged satellite and in situ data Global Daily SST (MGD), and Operational Sea Surface Temperature and Sea Ice Analysis (OSTIA) constructed by merging several SST data. It is of note that the characteristics of SST products depend on the type of SST used within the product, rather than the data source used. A comparison of SST products was also conducted using EMRP and data observed by moored buoys. The results show that only AMSR-E has a warm bias (+0.06°C) while other products have a cool bias (maximum value ?0.10°C). The RMS error of TMI is the highest (0.57°C), and that of EMRP the lowest (0.28°C). Furthermore, the temporal variability between the data in each SST product was compared to those observed by the Kuroshio Extension Observatory (KEO) buoy. Results show that the temporal variability of EMRP corresponds well to that of buoy data, and that the RMS error of EMRP is lower than that of the other SST products.     

Focal calcium monitoring with targeted nanosensors at the cytosolic side of endoplasmic reticulum

Ca²⁺ distribution is spatially and temporally non-uniform inside cells due to cellular compartmentalization. However, Ca²⁺ sensing with small organic dyes, such as fura-2 and fluo-4, has been practically applied at a single cell level where the averaged signal from freely diffusing dye molecules is acquired. In this study, we aimed to target azide-functionalized fura-2 (N₃-fura-2) to a specific site of subcellular compartments to realize focal Ca²⁺ sensing. Using scAVD (single-chain avidin)–biotin interaction and a copper-free click reaction system, we linked N₃-fura-2 to specifically-targeted scAVD protein fused with a red fluorescent protein mCherry, so that Ca²⁺ sensors conjugated with four N₃-fura-2 dyes with dibenzocyclooctyne (DBCO)-PEG4-biotin as a linker were generated at subcellular compartments in living cells. In cytoplasm, N₃-fura-2 showed a prolonged retention period after binding to scAVD. Furthermore, the reacted N₃-fura-2 was retained inside cells even after free dyes were washed out by methanol fixation. When scAVD was overexpressed on endoplasmic reticulum (ER) membranes, N₃-fura-2 was accumulated on ER membranes. Upon histamine stimulation, which increases cytosolic Ca²⁺ concentration, ER-localized N₃-fura-2 successfully sensed the Ca²⁺ level changes at the cytosolic side of ER membrane. Our study demonstrated specific targeting of N₃-fura-2 to subcellular compartments and the ability of sensing focal Ca²⁺ level changes with the specifically targeted Ca²⁺ sensors.     

Acceleration of the Rate of Silver Nanoparticle Formation Using Microbubbles in a Sonochemical Process

The effect of the addition of microbubbles on the formation of silver nanoparticles produced in an ultrasonic radiation-mediated process was investigated. The addition of microbubbles with an area-based median diameter of 26.0?µm and a bubble volume density of 0.18?cm³/L significantly increased the silver nanoparticle formation rate during the sonochemical process. The size distribution of the silver nanoparticles was largely unaffected by the addition of the microbubbles. The influence of changes in the microbubble volume density on the formation of the silver nanoparticles was also investigated; it was confirmed that the rate of formation of the silver nanoparticles increased moderately with increasing volume density. The gradient in absorption spectra was approximately 30 times larger for the case when microbubbles (median diameter: 28.3?µm) were added at 0.74?cm³/L, compared with the case without microbubbles. The results suggested that the microbubbles provided reaction sites similar to cavitation bubbles in the ultrasonic reaction.     

Characterization by Stm and Electrical Conductivity of Single-Walled Carbon Nanotubes

Abstract

Single-walled carbon nanotubes (SWCNT) prepared by a DC-Arc-Discharge and purified by a hydrothermal treatment followed by several steps of procedures including heating, burning, extracting and acid-washing are investigated by a conventional STM technique morphologically and spectroscopically. The electical resistivities of compacted pellets (mats) of SWCNT are measured as a function of temperature in the range from the room-temperature to 1.5K. The behaviors seems to be essentially originated in the metallic nature of individual SWCNT.